PDA

View Full Version : dizzy oil leakin.. cont


redhachiboy
9th January 2009, 03:10 PM
posted this thread before the site went thru the portal and it didnt come out the otherside (i guess with everythin else!) and i lost all the info in it :(

Pretty much got an oil leak out of the dizzy - i think the seals busted..

A few people offered their advice about what to look out for when fixing it and it was gladly appreciated.

Couple of things i wanted to know were: 1) what main things to look out for and do when going in to operate? and 2) where do i buy replacement seals/rings from?

cheers again for the help!

al
n00bvak
9th January 2009, 03:13 PM
repco should have seals or go to toyota for fully hecktic manufacture spares prices
doony
11th January 2009, 04:44 PM
i got my dizzy o ring for under $4 from toyota inner and outer. had it in stock and ready to go.
redhachiboy
16th January 2009, 01:10 AM
yep that was the thread doony.. cheers!

well its all done.. took me all day but hey learned a few new things :peek:

odin auto's ended up having the right inner u-seal (part no. 400704N) and i 'pandered' and just got an o-ring from toyota- but found out later odin had one anyway.. (both $7.20)

870
oil leakin out bottom of dizzy

872

871

sorry no pics.. but both ring and u-seal were hard an knackered!

probably most tricky part was getting the dizzy gear off, had to drill out the pin in one end and punch it out (cos its mushroomed out on both sides) - was told if u try and punch it out without drilling you risk making a mess of the shaft and gear.. then replaced everything an yeh just stuck a roll pin in with abit of loctite .. sweet as!

marking everything helps big time ;)
doony
19th January 2009, 11:34 PM
good to hear mate!
learning is invaluable.
marvis
20th January 2009, 12:39 AM
Good to hear it's fixed.
vivioman
1st May 2010, 08:47 PM
I had the same problem as well...leaky distributor, but the O-ring was fine when the distributor was removed...turns out that the inner seal was dry and brittle, so probably the sealing effect was compromised.

I got the part from Statewide Bearings (very effficient guys) for ard $5. This is the inner seal (also known as TC10/20/7 - I got to know this from another forum, didn't see this post previously):

http://www.bikesutra.com/car/innerseal.jpg