View Full Version : Tap and die set? need to borrow....

22nd June 2010, 08:28 PM
Hey guys just wondering if anyone has a tap and die set that goes past 10mm on the southside that they would be willing to lend me for an arvo/couple hours?

I need (I think a 11mm x 1.5mm thread pitch tap) but not 100% so would like a few sizes either way just in case... need to get my daily back on the road a.sap and my set doesn't go to the size I require.... I'm so broke I can't really afford to buy a new set, can offer a tally of your choice for whoever can lend me what I need...


Danny t
22nd June 2010, 10:02 PM
Did you strip the thread? Because i have a re-coil kit for a M10 1.25 is a common thread on a corolla. Thats assuming you have a corrolla.

I have a tap set ill have a check tomorrow if i have a M11 tap.

22nd June 2010, 10:16 PM
Nah its for the central hub bolt that goes into the CV joint on a audi A4, chewed the inside thread out a little when I removed the CV.... my set only goes to 10mm and it was too small....

24th June 2010, 05:16 PM
got what I need, cheers anyway