Willofan
2nd April 2011, 05:11 PM
I have been searching for some 15x6.5 Albino's as a spare set for the TTA AE86 GT Coupe and now realise its a needle in a haystack job. Anyone who has some won't sell em or they have cracks and the ones on Japan Yahoo are way too much for shipping to justify.
I have managed to track down a spare centre from a nice gentlemen in Qld and I was wondering. If I have the pattern remade and cast to a similar style, would there be a market for them here? They would be made to suit Simmons inner/outers and make some slight changes to the casting to stiffen them up a little.
They could be made in 15" and 16" x 6.5 to 10" for both Front and Rear wheel drive. As they are hand made 3pc, the offsets can be produced to suit your car +/- 40mm. Stud pattern would only be 4 stud with PCD's from 98mm to 114.3. Centrelocks for racing is an option too.
This is not a group buy or advertisement and only looking for comments at this point. No, I am not a wheel manufacturer or seller.........just someone trying to get something made that I need!!!
Appreciate your intelligent comments. Thanks
1725517256
I have managed to track down a spare centre from a nice gentlemen in Qld and I was wondering. If I have the pattern remade and cast to a similar style, would there be a market for them here? They would be made to suit Simmons inner/outers and make some slight changes to the casting to stiffen them up a little.
They could be made in 15" and 16" x 6.5 to 10" for both Front and Rear wheel drive. As they are hand made 3pc, the offsets can be produced to suit your car +/- 40mm. Stud pattern would only be 4 stud with PCD's from 98mm to 114.3. Centrelocks for racing is an option too.
This is not a group buy or advertisement and only looking for comments at this point. No, I am not a wheel manufacturer or seller.........just someone trying to get something made that I need!!!
Appreciate your intelligent comments. Thanks
1725517256