View Full Version : Taking apart 3 piece rims.
marvis
11th March 2009, 10:44 PM
What do people use to reseal the rim?
Can I just tighten the nuts when a allen key/spanner or will I need a torque wrench etc?
Any more info I should know?
Thanks,
marvis.
Jonny Rochester
11th March 2009, 10:47 PM
You can use silicon.
Oversized 86
12th March 2009, 03:56 AM
i used blue selastic...you know that blue gasket making junk...
just run a line on the inside edge before you bolt it together...(same as with a diff)...or you can just run a thick bead around the join on the inside of the rim (where the tire will fit over)
works fine
Whip
12th March 2009, 01:34 PM
Torque wrench is needed i believe
Robo86
12th March 2009, 03:14 PM
yer id torque it and run a sealant
marvis
13th March 2009, 01:36 AM
Fuck.
Where can I get a wrench from to do the job and cheap?
Clinton
13th March 2009, 02:32 AM
total tools? do they even have that in brissy?
marvis
13th March 2009, 03:08 AM
Northgate.
What about repco or something?
marvis.
dr1ft-pig
13th March 2009, 03:29 AM
no need for torque wrench
but im dodgey to some.... i have dine this before... just do them up "FT" (fucking tight)
u will be right
marvis
13th March 2009, 03:44 AM
That's what I was thinking. I'll see how it goes and let you guys know.
Oversized 86
13th March 2009, 04:25 AM
i havent torque wrenched mine...just did them up FT then drove for about a week and went back over all the bolts and made them FT again...
havent had a problem yet...
the torque rating for the bolts is only around the 2NM mark anyway
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.