Removing broken bolts from the block

[Brenton 86]

This is fairly obvious but just thought id throw it up here.
When mounting up my slave cylinder after the gearbox swap i decided to take some frustration out on the bolts, bad idea.
http://www.ae86drivingclub.com.au/dcimages/4/8/4/3/110905.jpg

Luckly the break wasn't clean so the bolt had sheared off from the head and remained in the block.
Solution:
Whip out some wd40 or any spray lube and grease the puppy up good.

Then use a small screwdriver or centrepunch and mallet to hit the shards in an anti-clock wise direction. At first ur gonna have to belt the shit out of it, as itll be tighter than a nuns... But once its moving light taps will safice.

http://www.ae86drivingclub.com.au/dcimages/4/8/4/3/110906.jpg

Once you have made a few revolutions their should be enough exposed thread to use ur favourite pair of multi-grips to finish to job.

http://www.ae86drivingclub.com.au/dcimages/4/8/4/3/110907.jpg

[.wolfwood]

what a pain, least you got it out without too much trouble

[mrmatt]

And if u cant get the prick out. Give Steve Rickets a call if ur on the coast. he can get anything out of a hole. and he dont muck around http://www.ae86drivingclub.com.au/forums/emoticons/2thumbs.gif

[Wally]

drill it out...

if you cant get it out...

[Peter]

This is alot cleaner then drilling it out.
But a pain in the arse. Good work.