v-tec
6th March 2008, 09:30 AM
Car is now definately up for sale, I am Chasing $7,000 for it
The car comes as previously stated, with such things included as rego, RWC, the required mod plates, a brand new RPM heavy duty clutch (still in the box).
I also created a log-book of the car since I have owned it stating all parts changes and oil changes completed during the time of my ownership. The car has always been run 98 Octane and Penrite HPR oil. I also have the original receipts the previous owner had for the motor being imported. As well as all receipts for work I have had done on it since my ownership. The car will come with a fresh oil change before it is sold. I will also chuck in a full Tank of fuel if the 7k mark is reached.
One thing I should point out is that the car has about 570,000k's on the dash. Obviously though the motor has been replaced, the car is still straight, rust has been removed (I don't know how much there was as I didn't own the car when it was done but there is none now) and its had a full respray. The car has its share of problems, as do all ae86s and cars of this age, however I would consider it much cleaner than many cars I have seen go for sale in my time.
As said, if you don't believe me, you are more than welcome to come see the car.
I had previous thoughts that the piston rings are going in the car, hence why i bought the clutch to go in at the same time as rings were getting done. It has come to my attention (thanks 70XIN) that its more than likely only the valve stem seals that will need replacing.
Here is the current specs of the car
Engine, Exhaust & Drivetrain:
Jap 4age 16v (rwd setup etc) (i have the receipt from it being imported too, motor apparently had about 80-100,000k's on it
Jap T50 (drivers side slave)
Twin core excel radiator with two standard thermo fans
New bosch battery
Standard driveshaft and rear end
TRD copy extractors
Stock size exhaust, very quite... good for daily.
New heavy duty clutch will come with the car, if i get the piston rings done anytime soon its going in with it.
HKS pod filter
Splitfire leads
All modplated etc for motor conversion
Suspension:
AJPS Front 6kg springs
AJPS Rear 4.5kg springs
Standard shocks
rear strut brace
(handling feels awesome with those springs alone, ive been itching to get a full set of TRD shocks which would just make it perfect but just havent had the time to do it)
Feet:
ROH 15x7 with some lowish offet
Potenza Re001's on front 195/50
Potenza GIII's on rear 195/50
Outside:
Full respray in Supra Anthricite Grey, interior and engine bay as well.
No Rust
Late model Whiteline Tailights
http://www.ae86drivingclub.com.au/dcimages/4/8/4/3/158434.jpg
http://www.ae86drivingclub.com.au/dcimages/4/8/4/3/158435.jpg
http://i21.photobucket.com/albums/b280/no-v-tec/ae86001.jpg
http://i21.photobucket.com/albums/b280/no-v-tec/ae86002.jpg
http://i21.photobucket.com/albums/b280/no-v-tec/ae86003.jpg
http://i21.photobucket.com/albums/b280/no-v-tec/ae86004.jpg
http://i21.photobucket.com/albums/b280/no-v-tec/ae86005.jpg
http://i21.photobucket.com/albums/b280/no-v-tec/ae86006.jpg
http://i21.photobucket.com/albums/b280/no-v-tec/ae86007.jpg
http://i21.photobucket.com/albums/b280/no-v-tec/ae86008.jpg
http://i21.photobucket.com/albums/b280/no-v-tec/ae86009.jpg
http://i21.photobucket.com/albums/b280/no-v-tec/ae86010.jpg
http://i21.photobucket.com/albums/b280/no-v-tec/ae86011.jpg
http://i21.photobucket.com/albums/b280/no-v-tec/ae86012.jpg
http://i21.photobucket.com/albums/b280/no-v-tec/ae86013.jpg
Hyundai Excel radiator and twin thermo's
http://i21.photobucket.com/albums/b280/no-v-tec/ae86014.jpg
Drivers side clutch salve (Not near the exhaust like Adm)
Something to also note is the car has had a full respray, interior and exterior. The car used to be white.
As said, This is no longer EOI the car is definately for sale and I'm looking at 7k ono.
Of course the price is open to negotiation, however due to the interest I have had in the car I will take the best offer I get. That said, it is first come first serve.
You are all more than welcome to come see the car, ask questions, and ask for photos and other information. For those that have asked about shipping/posting the car I can supply as much information as you require about the car.
if your genuninely interested please PM me on this forum or call 0423 049 869 and ill get back to you
Cheers
The car comes as previously stated, with such things included as rego, RWC, the required mod plates, a brand new RPM heavy duty clutch (still in the box).
I also created a log-book of the car since I have owned it stating all parts changes and oil changes completed during the time of my ownership. The car has always been run 98 Octane and Penrite HPR oil. I also have the original receipts the previous owner had for the motor being imported. As well as all receipts for work I have had done on it since my ownership. The car will come with a fresh oil change before it is sold. I will also chuck in a full Tank of fuel if the 7k mark is reached.
One thing I should point out is that the car has about 570,000k's on the dash. Obviously though the motor has been replaced, the car is still straight, rust has been removed (I don't know how much there was as I didn't own the car when it was done but there is none now) and its had a full respray. The car has its share of problems, as do all ae86s and cars of this age, however I would consider it much cleaner than many cars I have seen go for sale in my time.
As said, if you don't believe me, you are more than welcome to come see the car.
I had previous thoughts that the piston rings are going in the car, hence why i bought the clutch to go in at the same time as rings were getting done. It has come to my attention (thanks 70XIN) that its more than likely only the valve stem seals that will need replacing.
Here is the current specs of the car
Engine, Exhaust & Drivetrain:
Jap 4age 16v (rwd setup etc) (i have the receipt from it being imported too, motor apparently had about 80-100,000k's on it
Jap T50 (drivers side slave)
Twin core excel radiator with two standard thermo fans
New bosch battery
Standard driveshaft and rear end
TRD copy extractors
Stock size exhaust, very quite... good for daily.
New heavy duty clutch will come with the car, if i get the piston rings done anytime soon its going in with it.
HKS pod filter
Splitfire leads
All modplated etc for motor conversion
Suspension:
AJPS Front 6kg springs
AJPS Rear 4.5kg springs
Standard shocks
rear strut brace
(handling feels awesome with those springs alone, ive been itching to get a full set of TRD shocks which would just make it perfect but just havent had the time to do it)
Feet:
ROH 15x7 with some lowish offet
Potenza Re001's on front 195/50
Potenza GIII's on rear 195/50
Outside:
Full respray in Supra Anthricite Grey, interior and engine bay as well.
No Rust
Late model Whiteline Tailights
http://www.ae86drivingclub.com.au/dcimages/4/8/4/3/158434.jpg
http://www.ae86drivingclub.com.au/dcimages/4/8/4/3/158435.jpg
http://i21.photobucket.com/albums/b280/no-v-tec/ae86001.jpg
http://i21.photobucket.com/albums/b280/no-v-tec/ae86002.jpg
http://i21.photobucket.com/albums/b280/no-v-tec/ae86003.jpg
http://i21.photobucket.com/albums/b280/no-v-tec/ae86004.jpg
http://i21.photobucket.com/albums/b280/no-v-tec/ae86005.jpg
http://i21.photobucket.com/albums/b280/no-v-tec/ae86006.jpg
http://i21.photobucket.com/albums/b280/no-v-tec/ae86007.jpg
http://i21.photobucket.com/albums/b280/no-v-tec/ae86008.jpg
http://i21.photobucket.com/albums/b280/no-v-tec/ae86009.jpg
http://i21.photobucket.com/albums/b280/no-v-tec/ae86010.jpg
http://i21.photobucket.com/albums/b280/no-v-tec/ae86011.jpg
http://i21.photobucket.com/albums/b280/no-v-tec/ae86012.jpg
http://i21.photobucket.com/albums/b280/no-v-tec/ae86013.jpg
Hyundai Excel radiator and twin thermo's
http://i21.photobucket.com/albums/b280/no-v-tec/ae86014.jpg
Drivers side clutch salve (Not near the exhaust like Adm)
Something to also note is the car has had a full respray, interior and exterior. The car used to be white.
As said, This is no longer EOI the car is definately for sale and I'm looking at 7k ono.
Of course the price is open to negotiation, however due to the interest I have had in the car I will take the best offer I get. That said, it is first come first serve.
You are all more than welcome to come see the car, ask questions, and ask for photos and other information. For those that have asked about shipping/posting the car I can supply as much information as you require about the car.
if your genuninely interested please PM me on this forum or call 0423 049 869 and ill get back to you
Cheers