Did you pull apart both sides? If you've only done one side use the other as a referance
Hey Guys
Well me being me, pulled apart my drum hand brake assembly in the MX73,
Does anyone have a diagram of how they go back together.
I get the basic principle, but not sure on the order and what not.
A diagram from any disk overdrum setup would help i imagine
Cheers
Did you pull apart both sides? If you've only done one side use the other as a referance
i did pull apart both sides...
small spring at bottom
adjuster sits in the little [ ] shaped nook the shoes make
big spring goes over or above adjuster
pins go through the back towards the outside of the car and twist locks on
gently hold open while you get the cylinder in
rinse the whole lot with slightly soapy water
slacken handbrake cable right off at the lever inside the car
wind adjuster so that the drums only just go on and when you turn the axle you can only hear the faintest of rubbing noises
take up slack under the car
fine tune at lever inside car.
drink beer.
wheelfriends.wordpress.com
I know this is an old thread but i believe this is exactly what your looking for.
Last edited by YRO 11A; 1st July 2014 at 01:59 AM.
dead link?