i'm sure most of this has been covered through the thread but not in an entirely direct manner.
i will be using Power Steering arms, lock spacer and XT130 LCA's on an AE86 Strut.
heres my questions, inb4 flaming for noobness or not reading thread properly rabble rabble.
1. i know i need to cut off the lock stops but when i rebush/joint the LCA do i use Xt130 ones or AE86 ones?
2. will it be necessary to run different rack ends or tie rod tubes/ends?
3. if so do i just want the tie rod ends or tie rod ends + tubes?
4. will any of this change when i coil over the strut with Camber Tops and RCA's?