I just bought mine from my friend, straight up. But yeah, I know they are around.
Eh, it really won't be hard just to get an M12x1.25 fine bolt and tap a thread into it.
you could ask around to people that have jap dildo knobs. all jap dildo knobs i have bought and sold came with thread adapters. but for ease sack just drill and tap a bolt.
Simply for ease and less fucking around TBH. I can be kinda lazy like that. The problem with drilling and tapping a M10 hole into a M12 bolt is you dont have a very thick wall going over the M10 thread.
Another option is to linish the M10 nissan thread off, weld a 12mm O/D sleeve (Say a piece of 12mm hollow round bar with a 2mm wall) over the shifter itself and run M12 x 1.25 die nut down it.
Member of the Cable-Tie Cartel.
go to bunnings and get a bit of rubber cap to slip over it and screw it on
still need something? I can make something up on my lathe if you want it
My website: SQ Engineering - 4AGE and 3SGE upgrade/replacement parts
- SQ Engineering on facebook -
Please e-mail to contact me instead of sending a private message on here.
Sam Q to the rescue.
i was going to say, if you are REAL desperate and moneys not an issue that i could buy you a dildo knob here with thread adapters, but sam's option is FAR better.
this gear knob must be worth some bit to go through all this trouble...pics?
dose
I did something similar - found a black gear nob off a forklift and wrapped push bike rim tape (covers the spokes, material tape ~1.5 mm thick) around the treaded section and a little lower and screwed it on - worked a treat
Cheers, plohl