Weds are MINE!
Guys I'm clearing out my wheel surplus, All Japanese made in good sizing/offsets. I really need to clean up space in my garage so they're priced accordingly. They are as follows:
A set of FOUR Enkei Apache IV Meshies- 5X114.3 PCD - Fronts 14x7 + 5 offset, Rears 14x8 -7.5
Description: Very rare wheels in excellent sizing, will clean up nicely- Paint on the centers is poor + pitting on the barrels (They were very filthy in the photos + indoor flash photography doesn't do them justice). NO CRACKS, however they do have a bit of guttering & two have very slight buckling as per photographs.
Center spigot hole has been bored out a little- doesn't detract from their look at all though (previous owner had them on an XC Falcon and had them modified to fit).
PRICE $380 for the set! - Very cheap! Will need redrilling/hub adaptors to suit a Sprinter etc. Hence the price.
A pair of TWO Weds sport Tri-spoke single piece wheels- 4x114.3 PCD, 14x8 -15 offset
Description: These are very light single piece wheels in good condition for their age. Have very slight pitting- most of what showed up in the photos was actually dirt & grime (again- indoor flash photography), they will clean up nicely with minimal effort. NO CRACKS. Very slight guttering and light cosmetic denting around a couple of the stud holes as per photographs.
PRICE: $420 for the pair (You'd be hard pressed to find similar Japanese made wheels cheaper).
LOCATION / POSTAGE: I'm located near Ballina & Byron bay NSW (A bit less than an hour from the Gold Coast). I'd prefer pick up in person, however I will consider couriering them via busfrieght at the buyers expense if someone is really keen on them.
CONTACT: PM me here and we can take it from there. Can provide contact phone number- just ask.
Cheers
Matt
Weds are MINE!
shotty meshies lolz
i make shit ,i brake shit , i buy more shit to make shit
can you measure the centre of the mesh rims please, across the face.cheers
I will finish ,One day.
If the Weds Fall through please let me know ! I'm in Sydney but would arrange some sort of postage
Also - can someone explain how those meshies could be re-drilled to 4 x 114.3 ?
I did some research and depending on the design they can either fill in the old holes and redrill or do otherwise - But doing it to the above wheels look's pretty tricky!
PM Sent with my contact info if the Weds fall through
Don't hold your breath bro, am picking up asap provided I was first in.
I understand bro - I just wanted to make sure if it fell through my interest was noted =)
Hey guys- all the wheels are spoken for pending reply back from the guys that got in first (damn that was quick!). I'll let the ones that got in second etc. know if the first guys fall through.
Cheers
Matt
No Problems Thanks for the update!
Any updates on these ?