How To: 4AGE conversion into ke70 wiring

[Brendan]

the following is for a jdm ae86 4age motor into a ksev

The way I did my wiring was simple: on the loom to the ecu there is a plug that has a black and orange wire and a black and white wire (there are more wires but not as important). Give the black and orange wire power from the run position on the ignition. The black and white wire needs power from the start (crank) position on the ignition. Then on the 14 pin plug on the ecu, connect the two red and blue wires and the red and white wire together which also requires run power.

I can't remember if the ecu needs direct power but if the above doesn't work try run power to the yellow wire on the ten pin plug on the ecu.

Also make sure you have the motor well grounded.


Tommorow I will work on altenator wiring

Peace out for now