4AGZE Injector power, how do i give it power?!?

[s3phro]

Heya Guys,

Sooo close to getting my car started, i just need to get power to the injectors then my fuel pump..

I've got spark and everything else but I can't seem to find where I give power to the injectors, they have ground but I'm lost from there.

This is for a AW11 4AGZE (AFM/DIZZY) in a AE86..

Thanks!

[Nikkojoe]

They get power from the injector resistor pack. Its a square box, with a heat sink, and a yellow 3pin round plug (grey on later models). Only one wire (either black orange or black red) on this plug is the power source, the other two go to each pair of injectors.

[s3phro]

I don't think I have this... is it attached to the block or does it hang off the loom?

Otherwise I'll need to find a replacement somewhere..

[Nikkojoe]

Hangs off the loom. For a temp measure you can just feed power directly to the pins of each pair of injectors. It will be fine for a short period of time...