4age Slave master cylinder

[v-tec]

hey if you know what the slave master clyinders look like on these, there is small rubber bit on the end of that extends out to push in the thing inside the gearbox


sorry, my technicall terms suck balls

the one on mine is pretty corroded and just seems like it obviously needs to be replaced. Would i have to get one of these delivered from toyota? or should it be easy enough to just find one at a toyota wreckers?

any info helps

thanks

[OBE353]

If its pretty corroded it might b time for a new slave cylinder as the seals r most likely worn too.......u can get new ones fairly easily from parts places like global,repco, bursens etc.

Im assuming u have a T-50? so thats what youll have to ask for it doesnt matter what engine (4ac,4age) just gearbox.

they arent too exspensive from memory?

[v-tec]

ok cool obe, ill look into that...



thats it there... the rubber thing im hold i figure needs to be replaced, the cylinder itself doesnt seem to need replacing but its probly worth doing

[SprinterTRD]

Yeh just buy a new one, you can bet that if you replace the rubber you will be replacing the cylinder pretty soon.

[andru_g]

u can buy all those rubbers n seals n shit from repco etc..

[japlish]

It would nearly cost as much to buy a repair kit. Then to just buy a new one. There cheap any way.

[deltathing]

mm i just rebuilt mine the other day.
cost me about 17$$ for a new seal kit and piston.
from pbr.

[v-tec]

madness... cheers

[Monk]

deliverd?

man just walk down to toyota. it aint that far

[riceburner]

Or you could bore it out a little and use bigger piston form a different car.

I did. cost me $40

Made clutch a little lighter on the foot, only a small amount. Wasnt worth it really, but meh?


Cheers

Steve