Trueno Sedan

[Paul]

SNAP!I remeber this car. I was at QLD transport and saw this getting registered by the guys from 999.

[lo_rolla]

Yeah I bought it off Lachlan.
He was very helpful at first, replaced my muffler for free, replace clutch slave seal for free all that.

But then I had no money...

So I'm doin it by myself, yo.

[lo_rolla]

Can any one point out a reason why I can't adapt JDM frton discs and calipers to the rear? Remember I'm in the Automotive biz, so I know cunts.

I'm going Civic rotors with FC calipers with AJPS adapter up front, see if I cant make the back sexier with my new wheels.
Will I need new master / slave for the brakes.


In the next few weeks expect:
Tomei pro cams 304* / 11mm cams
TODA inner shim buckets, springs, spring seats, retainers and collets
Toda 11.5:1 pistons
TRD or TODA 0.5mm H/G
TODA main bearings
ARP main studs (if any one of you guys know where I can get billet caps let me know)
Gonna knife edge/lighten crank, shotpeen, cryo etc crank (need a new one - will trade 010 / 020 crank + $ your way for one)
Clutch
1 piece tailshaft
fancy fuel system
some federals from Robbie
Annnnnnnnnd,




Any one got bits I might ned make sure you let me know.

You handsome motherfuckers have been a great help these past few years;
brb, getting drunk / already drunk.

Thought I'd edit this a little, sound like a douche. I talk shit when I'm drunk.

[fantapants]

basic reason i can see is that there is no handbrake mechanism.

thats all i got. enjoy the drinking

[lo_rolla]

Another box came here today.

[lo_rolla]

Just purchased from AJPS

Civic Rotors
FC Calipers + rebuild kit
FC Adapter
ADR Braided Lines
Pads

[lo_rolla]

Car should be close to rust free and rolling on the equip 01's with 195/50's (or55's, advice??), nearly the full AJPS catalogue and semi prepped prepped for pain by the end of this month.

I've got some cats to help out with all the gear and some one to weld my car / show me how to use my yet to be purchased welder.

I'll take photo's showing the whole she-bang over the coming weeks.

Cheers.

And does any one like my chances of getting this car plated / registered?

[doony]

this car is beerlicous

[ae86]

not 55's this build is quality keep it goin

[lo_rolla]

This showed up this week.

Civic rotors
FC Calipers
Adaptor
Braided lines
Bendix pads
AJPS Handbrake button

And some 8mm bolt on spacers if I need them.

If I machined that little nub off the side of the caliper will it fit without clearance issues??

Any ways, thanks for the kind words guys.

Engine parts will hopefully be fully ordered by the end of next week. Hopefully.
And hopefully own a mig welder over the weekend.

Anyway few questions
1. Who should I see for a 1 piece tailshaft in Brisbane?
2. Any one got a FRP trueno bonnet I can buy?

And that's about it.