Reply With Quoteyou probably have to mod the dash, i had to change a resistor in it when i went from dizzy to cas on my 4agze
for all u people with sr conversions!!!
have any of yous managed to get ur tacho working the guy that did my wiring said i cant wire it to the stock dash cause stock 86 motors run dizzy and sr20det runs cas. is there anyway to make it work or will i need an aftermarket tacho?
cheers
you probably have to mod the dash, i had to change a resistor in it when i went from dizzy to cas on my 4agze
mine has a little plug thing with mitsubishi tacho interface written on it. from a 20v with cas
RIP Carly - a smile to light the world.
06/07/2011
does anyone know who can wire it up for me
yeh i want my ca working with factory tacome and sprinter86 tried to get it working using the same resistor setup as the 4agze but it never worked. at one stage it seemed like it was getting half a signal from only one plug.
keen to find out if anyones works
T18 in the build
get a pin out diagram from your ecu run a wire from tacho pin on ecu to your dash tacho black thick wire on the plug on the left side by mem but it may differ from e7 to 86
the dyno pull to 300rwkw
BT20v is making 300rwkw like i said i would without nitrous so now its time for some spray and see if she will run a 10s or less
use the SR instrument cluster
Posting Permissions