What kind of steering arms will i need???
and why???
Hi guys.
I am looking to undertake a corona lca coversion on my 86.
What advise or info can you guys give me in regards to doing the job???
Cheers.
John.
kiss ass like a bitch, so you can get ritch... but your boss gets ritcher of you!!!!
What kind of steering arms will i need???
and why???
kiss ass like a bitch, so you can get ritch... but your boss gets ritcher of you!!!!
The ones off your old LCA / strut.
Why? Because the bolt spacing is different on Corona LCA's, also the steering arm is longer (slower steering speed).
You can have any brew you want... as long as it's a Datsun / Corolla / What is that?
I have a sprinter... Will i need to change the steering arms???
kiss ass like a bitch, so you can get ritch... but your boss gets ritcher of you!!!!
No.....
RT142 Estate.
AJPS.
Nope.
so its just a straight bolt in???
kiss ass like a bitch, so you can get ritch... but your boss gets ritcher of you!!!!
Assuming they are xt130 lca's, the steering arms would bolt up to 86 struts (same bolt spacing, slightly different offset from balljoint though), but as said no point using them.
1983 AE86 ADM rust spec goodness track car build - end of the road
1984 AE86 Silver ADM mk2 daily build - SOLD
1984 AE86 ADM granny car daily now 4AGZE - SOLD
1983 AE86 ADM Engine Conversion Slut - SOLD
2002 IS200 6spd - new daily in progress
1986 AE86 JDM GT-Apex Levin Notchback ready to roll......
How to change LCA.
1. Jack car up
2. Unbolt LCA at cross member.
3. Undo Caster Rod and Swaybar Link Pin
4. Use a allan key to remove the bolts that hold the steering arm on the strut
5. Remove Tie Rod End.
6. Remove the whole control arm.
7. Remove steering arm from the LCA
8. Put the Steering arm on your Corona LCA
9. Put everything back.
10. Get a Wheel alignment