Theres a thread in the technical articles section explaining this, I think its quite a good run through from memory.
After help with installing hydraulic pedal box in my ke. Going to be using t18 one and just bit worried about were to drill holes to mount slave cylinder and clutch master. Pictures havent really helped me and people have explained to me but dont understand it 100%. Wondering if anyone in Adelaide can give me a hand or has a template I can use. Really appreciated. Also if your not going to help and are just going to say stupid shit to pay me out then get a life cause you need one if your hacking into people who dont have alot of experience with these sorts of things. Cheers Troy.
Theres a thread in the technical articles section explaining this, I think its quite a good run through from memory.
im pretty sure when i did mine there was provision for the MC.
I bolted up the pedal box and looked to see where it would line up, and there was a raised section in the engine bay that matched the MC size. i Just drilled lots of little holes around the inside of the circle and then hit it out with a hammer, then cleaned it out with a dremmel.
THis was for a ae71 box, im assuming the t18 box uses the same position for the MC.
so just have a look for the rasied section on the firewall.
hope this helps.
if you want, when i come round i can mark the fire wall in the correct spots for you to drill out from there?