12A? ew
Bought a few months ago and being used as my daily
P plater spec
1983 ADM
4AC
DCOE Webber
2 1/2" exhaust
T50
Single 1 piece shaft
S Series
Black interior
Driver race seat
SUSPENSION:
Front: Chopped Kings
Rear: AJPS 6KG
RIMS:
16x6 aw cobras? x 4
14x6 dragway draglite rims x 4
Its getting the repairs painted this weekend.
Plans are for 12AT rotary and r31 Borgy rear end
and some decent front & rear coil overs!
Last edited by FUTO_GT; 15th January 2009 at 03:34 PM. Reason: pic's
12A? ew
ur in wavel heights jus off rode rd correct?
whats with the 12a? you got one already hanging around? do it once do it right brah.
what manifold do you have on the 4ac?. Engine bay pics please
ew 4a!
NAh man, not me.
Yeah hear that! I've got set up from my S3 Rx7. Genuine decomp 12AT extend port block,
microtech, made 235rwhp with hiflow s5 turbo on 12psi, plus s5 turbo box and button
clutch all just sitting around ready to go.
Its just the stock intake with redline webber adaptor. I get pic's for you.
Last edited by FUTO_GT; 3rd January 2009 at 09:36 AM.
nice bay, btw a dcoe is a sidedraft
this car is from brizzy yeh? does it have a retrimmed dash? It looks familiar...
------------------>>>Need something welded locally??? Hit me up, I may just be able to help<<<------------------
BENT MECHANIX - Garage 20:
iv only been there once but those pics do look like they were taken in brisbane..
12a is a bit of an odd choice. why not go 13b?
Whoops, my bad. Tell you the truth I haven't even pulled off the air cleaner and looked at it yet, I just new it wasn't IDA or IDF, so I guest it was DCOE.
Yeah BNE = Bris. There no dash top when I bought it, so might be same one?
Already got 12AT engine ready to go, as I said above, but if you want me to go into it, I've played around with rota's for over 11 years now, I worked for mazda for 4 of them, and it is my opinion 12AT is a much better designed motor then Series 4/5 13B. There is no need to use extra dowels on a 12AT making ~400+hp as tend not to twist and break rear plates like series 4/5 13BT motors do. Also 12A parts are cheap as. I've already got this good motor ready to go so why not use it. If I was to go 13BT it would be FD3S series 6-8 motor, but bit out of my buget range right now.
Last edited by FUTO_GT; 15th January 2009 at 10:33 AM.