anybody have any wild ideas how to get the crank pulley of my 4agze? bolt is off but the pulley is just stuck on the keyway or something?? if i tap it with a hammer either side you can feels it shifting but it just dosnt want to come forward
anybody have any wild ideas how to get the crank pulley of my 4agze? bolt is off but the pulley is just stuck on the keyway or something?? if i tap it with a hammer either side you can feels it shifting but it just dosnt want to come forward
buy a gear puller from your local tools store and it will do the job without damaging the keyway etc.
doesn't it have bolt holes on the pulley so you can make your own puller using some flat steel?
T18 in the build
then wait till u get to the cam belt crank pulley.... uoooooh!!!
AE86 THE BEST
dont waste your money on a gear puller.
awsome old school trick i learned, turn the motor to tdc then turn it over a tiny bit more, pull out spark plug number 1m grab some twine or thin rope and feed in as much as the cylinder will take. turn the motor back to around tdc and it wont move any more
undo the bolt with the largest breaker bar you can make/find
i have the bolt off its the pully wont come off now,i used a rachcet on the flywheel bolts to stop the engine rotating..but its a 2 man job
You can buy harmonic balancer remover tools. They are a universal fit and use a pretty standard thread. Even a steering wheel remover tool works
1983 AE86 ADM rust spec goodness track car build - end of the road
1984 AE86 Silver ADM mk2 daily build - SOLD
1984 AE86 ADM granny car daily now 4AGZE - SOLD
1983 AE86 ADM Engine Conversion Slut - SOLD
2002 IS200 6spd - new daily in progress
1986 AE86 JDM GT-Apex Levin Notchback ready to roll......