Who has the template for the hydraulic clutch into ke70??

[Golden Circle]

AS title states, PM me

Cheers
Clinton

[maxhag]

You dont need it dude....... I have done this mod 4 times, and never needed it... Just a tape measure, texta for marking, 32mm hole saw on drill, and look carefully......

[Matt]

I've found it easiest to drill from the inside out once the dash is out. Start with the thread on the ae71 peddle box and drill that, and then fit the peddle box. Bit of grease smeared on the end leaves a good mark where to drill. Then mark the other hole and drill that.

Drill a small pilot hole for the holesaw in the centre of the clutch slave area, and then drill with the holesaw from the engine bay in and smooth out with a file / die grinder.

[adds]

i put a simple way of doing it in by build thread. i wouldnt bother with templates and stuff