Will add pictures up on the weekend.
If someone wants to make a decent offer on the whole engine in RWD format,ECU with COP set up, with or with out the SC or GTIR parts I would consider it.
PM offers.
OK, so I have thought long and hard about this, and I have decided to ditch my 4A build for a bigger capacity engine.
Story is I was piecing this ST20V together, with the plans of full build with low comp forged pistons running the SC14 until I found a decent turbo set up.
SC14 set up not complete, needs finishing off, top mounting bracket, belt....
Engine is stock compression ratio, would recommend using a bigger head gasket or low comp pistons if you want to use SC14.
I have never run this engine with the supercharger.
Engine - SOLD
ST20V with Quads
RWD Format
Comes with dizzy
Alloy dizzy blank cap,
SQ rear bypass with heater pipe fitting,
SQ front thermostat pipe,
SQ exhaust side block off plate
Flywheel,
AE92 starter,
Extractor,
Water pump
Pullies
20V Alt with AW11 exhaust side bracket
Stock Injectors
Stock FPR
Sump has turbo drain.
Coil setup
SQ COP adapter, spacer and bolts, 4 x 1NZ Coil on plug
or
Bosch HEC715 x4 mounted on plate
Razorback ECU with full loom with every sensor, handset and manual
- has tune for stock ST20V running 4 coils in waste spark and open quads - tuned in TPS mode
Last edited by Futo_gt86; 14th August 2012 at 08:58 PM.
Will add pictures up on the weekend.
If someone wants to make a decent offer on the whole engine in RWD format,ECU with COP set up, with or with out the SC or GTIR parts I would consider it.
PM offers.
Last edited by Futo_gt86; 13th July 2012 at 08:05 PM.
Just as an example for shipping on the engine, I had a 220kg engine shipped depot to depot from South Dandenong to Brisbane on a 800Lx800W pallet x700H, for $120 on E-GO Couriers
I have a ute, and am more then happy to put engine and gearbox on pallet for you and drop off to depot.
Check out below link for quote price. Extremely good service!
Last edited by Futo_gt86; 15th July 2012 at 12:52 AM.
All pm's replied to.
if the oil cooler kit dosnt sell i can come pick it up tomorrow bud.
cheers
0416702037
Not in any hurry Alex, thanks for the offer, but has dibs.
Like I say above, this is EOI right now until enough interest is generated.
Last edited by Futo_gt86; 14th July 2012 at 06:05 PM.
Updated prices with options.
$1600 for a ST20V and extractor in RWD format with quads & open trumpets with fully adjustable fuel and ignition ECU and loom?
I'll even throw in the engine mounts if you need.
Anyone?
Getting close to parting out, get in quick.
Hi mate,
Im heaps keen on st20v if your going to part it out for $950.
Im currently waiting for my tax return but i do have the cash if your keen to get rid of it asap.
Im also pretty keen on t50 box.
If you are going to part it out let me know i have cash ready to go..