Hey guys,

I am currently converting my ae71 to 4age. Being a smallport, im using a 212mm flywheel, with a brand new 212 Exedy HD Clutch. Upon mating the motor to the JDM T50, I discovered the fork movement is far far far less than my other stocko 4ac ae71. If i had to guess, movement of the 4age AE71 is about 5mm, forward or back. The 4ac on is about 20-30 mm back and forth.

To further my concerns, when I tried connecting my slave, the fork is so close to the slave that the only way it'll sit properly is if it sits at an angle, rather than straight on.

I did a rough measurement for the sake of it, and from the block (basically where the box mates to the motor) to the clutch plate is 84mm.

Its as though the t50 bearing is too big for the area from the pressure plate to the end of the gearbox shaft.

So either this is normal with the hd clutch, or ive got an issue.. Any ideas guys?