hay what do i set my torque wrench at to tighten my flywheel on my 20v 4AGE silvertop
ANYONE KNOW??
hay what do i set my torque wrench at to tighten my flywheel on my 20v 4AGE silvertop
ANYONE KNOW??
fucking tight, with loctite
Exactly what I was going to say. Hahaha..
haha yeah i know that but i need to know the numbers thanks anyways
whats the highest on your torque wrench?
HAHAHAHHAHAHAHAHAHAH
yeah dude as tight as the bolt will allow before you snap something, but good luck snapping something before you pull a muscle..anyways after all these clutch and flywheel changes on stock motors that sees 7500 very often, super hand tight has worked enough so tight as tight and you'll be alright.
dose
totally irrelevant but CA18 is 98-108Nm/72-80lb.ft
Also, overtightening is better than undertightening.
The flywheel bolt torque for a 4age 20v bt is 75nm's.
I presume the tension would be the same for bt and st
And thats straight out of the toyota workshop manual
don't over do it, they are only 14mm bolts
Last edited by rthy; 26th September 2012 at 10:40 PM. Reason: edited to correct bolt size as pre next page :>
30kw club