p.s i've also tried labelling the wires to what i think they may be but am not game enough to try it out
ok so i've finished making the engine harness but still no luck with the crank angle sensor wiring!
but what i did find out is this
this isn't a microtech harness plug and is just a generic one!
This plug, plugs into the 4 pin out on the actualy lt10s itself.. i've tried talking to microtech about it but there aren't the best with helping people out
so i guessed what colours should be what on the generic plug that i have... Could anyone confirm the pinouts for me ??
OR even if someone could send me a pic of what wires run where to there Cas on there 20v's
any help muchly appreaciated!!
twisty
p.s i've also tried labelling the wires to what i think they may be but am not game enough to try it out
did you ind out the pin outs bud