I couldn't get mine back together in hilux diff, was put together wrong felt alright but yeah.
Hey Guys
Welded center up and replaced bearing in an Ra60 T series center and then went to put the center back into T18 housing and it seems to be too wide ~3mm per side. The cones that set the backlash are hitting the diff housing. Then we measured the over all with of the centers and the RA center seems to be 6mm wider then the original T18 center. I was wondering if anyone has had this problem before?
Regards
Vaughn
Last edited by Vaughn; 8th February 2013 at 08:01 AM.
Just another Muppet
I couldn't get mine back together in hilux diff, was put together wrong felt alright but yeah.
"Not all commodore drivers are wankers, but all wankers drive commodores"
Do you have a picture of the differences.
It's in now, ended up just shaving a little bit off each side of the cones. Diff is working fine
Just another Muppet