looks like either excessive force pulling on the bolt(the crash) or even the bolts bottomed out and someone was still smashing it with a rattle gun,
Howdy partners,
I was converting a 16v 4agze from FWD to RWD yesterday when u came across this:
It is where the front engine mount attaches to inside the timing belt cover. The bolts were bent when i was taking it off, and i believe the car it was in previously did have a stack but was still drivable.
Just wondering if anyone has seen this before?
Cheers, Will.
SuperFunHappySliders
SR's are ghey.
looks like either excessive force pulling on the bolt(the crash) or even the bolts bottomed out and someone was still smashing it with a rattle gun,
Far out! I'll prolly pull this engine down to check out how bad the damage is!
SuperFunHappySliders
SR's are ghey.
you need a new block unless you want to do some seriously expensive repairs
My website: SQ Engineering - 4AGE and 3SGE upgrade/replacement parts
- SQ Engineering on facebook -
Please e-mail to contact me instead of sending a private message on here.
Yeh i don't want to use it, hoping to possibly use pistons though!
SuperFunHappySliders
SR's are ghey.
Oh sweet, cheers man!
SuperFunHappySliders
SR's are ghey.
your internals will be fine because you have a cracked area between the water galley and the outside of the engine. The way I see it is that for it to have enough force to go all the way to the bore this section in the front would of ripped right open.
My website: SQ Engineering - 4AGE and 3SGE upgrade/replacement parts
- SQ Engineering on facebook -
Please e-mail to contact me instead of sending a private message on here.