wiring up igniter

[slidernt]

got an igniter for a early 4age. has early dist and igniter. the wires on igniter to ecu are cut with no connector. So need to know which wires need to go where. got the wire to & from coil sorted. now the others are
#1 white
#2 pink
#3 brown
#4 coil ok
#5 yellow
#6 coil ok
dont want to sap this igniter into oblivion
got all the ecu wires /pinouts sorted just need to hook these up right

[pizzaeater]

What is the part number off the igniter, I have a bigport loom here I can check it against.

I know this isn't overly helpful but the wires you have to worry about are

Ign power / positive coil
Igf - check ecu plug colour in the position of the pin
Igt
Neg coil
Tach output
Ground

I'll have a look later tonight when I get home.

[slidernt]

part number reads 89620-12770
cheers

[Slimer86]

[Slimer86]

White connects to black with yellow stripe, middle ecu plug pin no. 5

Pink connects to black with blue stripe, small ecu plug (not the one which connects to start signal or circuit opening relay), pin number 8

Brown connects to black with orange stripe (ign 2 main switch feed to all engine electrics)

Yellow to black wire which is the tacho signal output.

I hope that helps

[slidernt]

ok white is IGF- igniter
pink is IGT - igniter
brown is +B1 main relay
yellow run straight to tacho on cluster

cheers

[Slimer86]

Not b1+. That is black with a red stripe isn't it?

The black with orange stripe is the main ignition feed for all engine functions.
Coil pack, injectors, etc

[slidernt]

ok thanks