Would you take the head assembed - So it can be pulled down, ported, then get re-assembled for an extra fee? You should list the types of heads you have done already.
Hey guys I am thinking of stating to do some head porting for people as part of my buisness. I have done a bit before with sucess. It would be at my place in Endeavour Hills and I would probably only want $150 for a complete clean up and reshape.
Would anyone be potentially interested?
I also can do diff conversions and dual caliper brackets for the rear
Last edited by Sam-Q; 22nd August 2009 at 10:35 AM.
My website: SQ Engineering - 4AGE and 3SGE upgrade/replacement parts
- SQ Engineering on facebook -
Please e-mail to contact me instead of sending a private message on here.
Would you take the head assembed - So it can be pulled down, ported, then get re-assembled for an extra fee? You should list the types of heads you have done already.
yes with quite possibly providing I have the right tool or have the time to make the right tool.
I havent done much so far:
datsun 2000
20v silvertop
20v blacktop
7afe
2TG
My website: SQ Engineering - 4AGE and 3SGE upgrade/replacement parts
- SQ Engineering on facebook -
Please e-mail to contact me instead of sending a private message on here.
I know it is but I dont own a flow bench, all I promise is that I take special care to make the ports even and thats it.
BTW I better clarify $150 is the average price for moderate deburring and reshaping, no elaborate contouring or for difficult heads as that would be a higher (but still cheap) cost.
My website: SQ Engineering - 4AGE and 3SGE upgrade/replacement parts
- SQ Engineering on facebook -
Please e-mail to contact me instead of sending a private message on here.