Keihin FCR41mm Carby's

[wild_70]

Hey all,

Brought these off ebay intending to put them on my 2tg/3t hybrid conversion, They are in A1 condition apart from ONE ram tube being broken. They would be great for any 4cylinder motor, but they are spaced out almost perfectly for a 4ag/2tg. These are top of the range motorbike racing carby's, and manifolds are available for these off yahoo (4ag 16v) if you can't fabricate your own.

Location: Bendigo, Victoria

Cost: $400 starting bid http://cgi.ebay.com.au/ws/eBayISAPI.dll?ViewItem&item=120579099325&ssPageName=STRK:MESELX:IT

Contact: PM ,reply here, or email me at... talbo_21@hotmail.com
More pictures on request.

[Pidgey]

Holy hot damn these are just what i would be after in 6 months. fuuuuuuck.
How/where did you get them? I cant find them inside Australia. you should hold onto them for a couple months :) lol.

[wild_70]

Tell me about it, they're near impossible to find under $1k. Found them on ebay relitively cheap so i thought id snap them up.

[resol]

omg omg omg omg quad carb NA sr20 :)

what choke size are they?

-dan

edit: der they are 41mm, do you know what size they could be upped to? maybe 45mm?

[af300e]

edit: der they are 41mm, do you know what size they could be upped to? maybe 45mm?

Maybe, but the 41mm flow for well over 50hp on a single cylinder so run them as is first. Smaller choke is win for lower engine speeds too.

[wild_70]

....bump

[slydar]

41 is the biggest they do. mikuni do 45.

there are no chokes btw... its just a massive 41mm hole with a needle in it.. hence they flow easily as well as a 45mm webber..

[wild_70]

Bump, found a better option.
reasonable offers considered.

[wild_70]

Now on ebay $400 starting bid
http://cgi.ebay.com.au/ws/eBayISAPI.dll?ViewItem&item=120579099325&ssPageName=STRK:MESELX:IT