FoldKing86
9th May 2010, 11:00 PM
Howdy Gang i have old random 4age bits i dont need as i went 20v. All this stuff was running fine in my 16v before the engine died and i went the 20v route. All parts were off a bigport!!
1* RWD loom - looks complete, had 4 wires cut (i believe its the section that runs along the firewall)
but i dont know electrical stuff sorry. APPEARS TO HAVE A MISSING WATER TEMP PLUG ON BACK OF HEAD SOLD
2* RWD dizzy - cap and rotor button looks clean, NO LEAKS.SOLD
3* RWD Coil and ignitorSOLD
4* RWD map sensor
5* T50 box, been rebuilt with bearings since i owned it. No bellhousing sorry. Oil seal at rear isnt all that old either, maybe 8000kms.
6* Davies Craig thermo setup to turn on the thermo fan, has the relay, temp probe etc needed. On temp adjustable. NO FAN SORRY JUST THE CONTROLLER. SOLD
7* TRD copy 20v extractors 4-1, i went a different way so i dont need these. A You can also have the heat wrap aswell. postage maybe a bit rich thou, im not sure. Approx 2000kms on them.
8* Oil cooler set up, magna trans cooler, lines, block adaptor. All you need is mounts for your car.
9* Brake rotors and Calipers, aus spec caliper rebuilt roughly 5000kms ago, slotted DBA rotors. NOT AVAIL TILL END JULY.
I prefer pick-up Newcastle area but i could post at you expense. All parts except box and extractors would only be $5 OZ wide
1* SOLD
2* SOLD
3* SOLD
4* $20
5* $130
6* SOLD
7* $150SOLD (PAYMENT PENDING)
8* $80
9* $200
Reply here or pm
1* RWD loom - looks complete, had 4 wires cut (i believe its the section that runs along the firewall)
but i dont know electrical stuff sorry. APPEARS TO HAVE A MISSING WATER TEMP PLUG ON BACK OF HEAD SOLD
2* RWD dizzy - cap and rotor button looks clean, NO LEAKS.SOLD
3* RWD Coil and ignitorSOLD
4* RWD map sensor
5* T50 box, been rebuilt with bearings since i owned it. No bellhousing sorry. Oil seal at rear isnt all that old either, maybe 8000kms.
6* Davies Craig thermo setup to turn on the thermo fan, has the relay, temp probe etc needed. On temp adjustable. NO FAN SORRY JUST THE CONTROLLER. SOLD
7* TRD copy 20v extractors 4-1, i went a different way so i dont need these. A You can also have the heat wrap aswell. postage maybe a bit rich thou, im not sure. Approx 2000kms on them.
8* Oil cooler set up, magna trans cooler, lines, block adaptor. All you need is mounts for your car.
9* Brake rotors and Calipers, aus spec caliper rebuilt roughly 5000kms ago, slotted DBA rotors. NOT AVAIL TILL END JULY.
I prefer pick-up Newcastle area but i could post at you expense. All parts except box and extractors would only be $5 OZ wide
1* SOLD
2* SOLD
3* SOLD
4* $20
5* $130
6* SOLD
7* $150SOLD (PAYMENT PENDING)
8* $80
9* $200
Reply here or pm