coilover conversion

[jmorley]

hey guys i am going through the stages of biulding my coilovers using the hsd sleeve kit just having a few problems. the camber top is fowling up on the top of the top hat im not sure if i have drilled the top hats out to sit in the right place or not but ill let the pics do the talking any help would be much apreshiated as i would like to get these biult have been putting it off for awile.

cheers josh

[jmorley]

having trouble uploading pics will try again tomorrow

[skin]

As long as you have the correct spacer between the two this should never happen regarded of where the top hat sits.. The top hat should however be drilled out to a non tolerant fit to the shock shaft diameter. The spacer will then sit on top of the flat machined part of the shock with the camber top to follow

[jmorley]

Yer sounds like I got the top hat in the wrong spot I'll throw some pics up tonight