Control arms

[Drew]

Hi guys

ive just got a dumb question ive got some standard 86 LCAs but they are ajustable. and they dont fit, they have a gap either side. can pack them out with washers, or what eles could i do?

Cheers

http://www.ae86drivingclub.com.au/dcimages/9/0/8/55268.jpg

[H8CHIR6KU]

depends. is the eyelet the same diameter as the bolt going thru it? if it is then yeah good washers will be fine.

the t3 kit comes with washers to fill the space.

if the eyelet is bigger then there needs to be a spacer that fits the eyelet and that the bolt can go thru

[Drew]

yeh the eyelet is bigger. i tryed to get those T3 spacers off joel but he had none

[H8CHIR6KU]

might have to get someone to spin some up for you on a lathe. shouldnt be too hard. measure the gap in the subframe then measure the diameter of the eyelet and then the diameter of the bolt. maybe ask sam if he can do some for you

[Drew]

thanks mate

[Sam-Q]

whats the inside diameter of those rod ends?

[Drew]

The hole is about 16 to 18mm

[Sam-Q]

I can machine something for you for a modest rate if you can wait. I need to get 3 jobs out that are waiting, and they have been waiting for a while.

[Drew]

Yeh prob. The car is getting sprayed real soon and I need to get the gaurds done before.