View Full Version : Distance bellhousing to center of gearshifter t50 box
Bozu
10th February 2011, 02:04 AM
Like the title says, I'm looking for the distance from the front of the bellhousing to center of gearshifter on a t50 box.
So far I've found on the internet that it's about 670mm, can someone verify that?
Cheers,
Bozu
86TRD
10th February 2011, 02:27 AM
Just measured a spare box and its 650mm. or there abouts.
deffinatly not 670mm though.
Bozu
10th February 2011, 02:41 AM
Sweet as, I was hoping someone had a sparebox and would measure it up, thanks mate!
Bozu
10th February 2011, 02:42 AM
Anybody knows this distance for the sr20det box?
And the sr20det box with rb20 bellhousing?
assassin10000
10th February 2011, 01:17 PM
I can confirm the above #'s from measurements I took when doing my W58 adapter.
From where the bellhousing mounts to the center of the shifter 'bucket' is 19 1/4" which is about 490mm.
From the front including the bellhousing (6 3/8") is 25 5/8" which is about 650mm
Andrew
Bozu
11th February 2011, 12:46 AM
And does anyone know these measurements for the 4AGZE box?
- The distance from the front of the bell housing to the center of the gear shifter
- The length of the bell housing
slide86
11th February 2011, 01:06 AM
there is no RWD 4agze gearbox, its either a t50, or a W series conversion
what are you trying to achieve?
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.