Coolant temp sensor thread size and pitch

[slide86]

I just need to buy an adaptor for my gauge

I need to know the thread pitch and size for the sensor that is in the water neck on the FRONT of the engine, not the rear.

My thread taps arent the correct size........:cries:

[Sam-Q]

dash temp? 3/8" BSP NPT, shit of a thing to tap. From my experience you only need to wind the tap in one third of the depth with a 14.5mm hole. I can do it for you if you like just throw me $10 and post and I am happy

[slide86]

yeah for dash temp

im trying to buy an adaptor to fit my autometer sender in there..........the ones in the kit are far too big (1/2 im pretty sure)

[Jonny Rochester]

From memory the aftermarket temp sensors are 3/8" NPT tapered thread.
The Toyota temp sensors are 3/8" BSP tapered thread. Both LOOK the same, small difference.

(I could have this backwards)

[Sam-Q]

yes backwards, only one extra thread per inch