Head studs or head bolts for 20v

[omy]

Has any one replaced there head bolts on the 20v, I have looked at ARP stud kit for it, which they don't have http://www.ae86drivingclub.com.au/forums/emoticons/sad.gif as the bolts on the 20v are longer. From what I have found, people in the usa are ordering custom made sets. Any info is good info.

Cheers

[mattysshop]

just get new ones from toyota.. i just got some new ones in my head.. cost $6 each..

[omy]

Got a part number for them? I called up toyota today and they are $30.00 each for the 20v A101? http://www.ae86drivingclub.com.au/forums/emoticons/sad.gif

[mattysshop]

call james in the parts department at Castle hill toyota NSW - 02 96802111

tell him your off toymods.. nice discount http://www.ae86drivingclub.com.au/forums/emoticons/wink.gif

[mattysshop]

mine were only the 16V once..

[omy]

$27.50 each for the 20v.

[mattysshop]

hahaha i spose it's still better than $30! ha ha ha

[omy]

Well the 16v are $6.00 each, the 20v ones are the same as the 16v exhuast side bolts, so I can just us them, also the 20v are allan heads not bolts.

[mattysshop]

to be honest i haven't seen under the skin of a 20v in all that detail, yeh the 16v normally are a 12pt 10mm bolt.. if the ex side is the same just use them.. ?

[omy]

The bolts

http://img223.imageshack.us/img223/2861/bolts8nm.jpg

[mattysshop]

they should be fine to use.. new ones though.. or just mesure the bolt stretch are your only ones not reuseable?

[omy]

What is with in spec for stretch?

[mattysshop]

i'll check when i get home.. i have specs for the 16v but not 20V sorry, but i'd say they would be similar.. do you not have inlet side bolts? or just wanting to use new ones?

[omy]

Just wanted to replace them with new ones.