4A-GE with sc12

[fat86s]

hey guys.. jus want to know if any1 has bolted up a sc12 to a 4A-GE?
jus wanna know how it ran, blah blah blah..

im thinking bout doing so, my gze block is F#kd n im lookin for a cheap way out. Iv heard there supposed 2 make decent power, can any1 back it up for me?

thanks heaps

http://www.ae86drivingclub.com.au/forums/emoticons/2thumbs.gif

[mattysshop]

they will.. but i wouldn't run too much boost through her... just swap the blocks over.. http://www.ae86drivingclub.com.au/forums/emoticons/wink.gif

[fat86s]

they will.. but i wouldn't run too much boost through her... just swap the blocks over.. http://www.ae86drivingclub.com.au/forums/emoticons/wink.gif[/b]

yea... im gonna run 9psi throught it until i have money for the turbo conversion, then il put my gze pistons n that in n crank it up a lil http://www.ae86drivingclub.com.au/forums/emoticons/tongue.gif

[TRD_86]

<{POST_SNAPBACK}> (index.php?act=findpost&pid=234876)

they will.. but i wouldn't run too much boost through her... just swap the blocks over.. http://www.ae86drivingclub.com.au/forums/emoticons/wink.gif[/b]

yea... im gonna run 9psi throught it until i have money for the turbo conversion, then il put my gze pistons n that in n crank it up a lil http://www.ae86drivingclub.com.au/forums/emoticons/tongue.gif
[/b]

i ran that setup for a while, and the only sorta safe way to go bout it, is to get a full management system. i ran a wolf system, with 14 psi, went really well, and it was in an ae82

[redsprinter]

whats involed in that. is it a big conversion? or straight bolt on?

[Jason]

gze pistons/rods bolt striaht in

[fat86s]

hey guys.. i finished putting my motor 2gether (bigport 4age with gze externals,microtech mtx8). Car started n runs smoothly. It made 146rw/hp@9-10psi on JEM's dyno.
Iv found that this setup starts n idles alot better than the 4agze.


http://www.ae86drivingclub.com.au/forums/emoticons/2thumbs.gif