converting ze to te

[albertos]

hello people ,im after info on this swap and some pics.ive been searching but not much luck

thanks

[DRFT - 86]

Maybe try searching again because there is tons of info on this man...............

[.wolfwood]

serch abit man, its not ealy a hard conversion, turbo, manafold, oil line, water line, intercooler, zorst. and perhaps a aftermarket ecu


thanks thats bout it.

pics of some of my shit

manafold.
[attachment=5106:attachment]

before welded up and shit

pic on car
[attachment=5107:attachment]

[albertos]

thanks for those pics wolfwood

ive been searching all night and cant find any good pics my motors ready to go in and i just need to no were all the hoses and lines should be,please point me in the right direction as i need to get this running on weekend

[reg450]

you should go for a 4agzte now that would rip up the track

[albertos]

pics or diagram links please

[reg450]

were abouts did you pic up the oil lines from wolfwood you tap into the oil switch run a t peice what did u use

[albertos]

im pretty sure i got oil lines and water for turbo done,im stil working out the hoses that run to inlet manifold its a fwd cut/shut and water lines for cooling

[.wolfwood]

im not sure how the oil lines were done, already dont when got motor, jsut got some hoes in the side of the block and a drain to the sump. migh t get pics later if ya still want em

[reg450]

yeah wolfwood id love pictures

[albertos]

thats a good wolf, get those pics up.. thanks

[.wolfwood]

yeah man will get em tomorow, dont have proper camera but got 3.2megapixel on my phone so will sue that.

[mc68]

thats a nice manifold ben, how much that set u back?

[mattysshop]

to give you a rough idea a manifold like that made from steam pipe all pulse TIG welded should have change from $500.. custom made.. nice merge collector etc.. see Craig - extreme engieering.. if you have seen 999 86.. lochlan got craig to make it and most of the fabrication on his car was done buy Craig

Craig @ extreme engineering - 0412432546

[.wolfwood]

i wish mine was only 500. it was closer to 800 with the new studs and shit

[.wolfwood]

here are spmeics of how ine is set up with oil and water lines.

[attachment=5215:attachment]
[attachment=5216:attachment]
[attachment=5217:attachment]

soz pics are gay quality there from my phone...

hope that sorta helps you out. the water line from the t part goes into braded line behind the block.

[mattysshop]

extreme engineering manifolds look much better than that http://www.ae86drivingclub.com.au/forums/emoticons/smile.gif maybe you should have shopped around http://www.ae86drivingclub.com.au/forums/emoticons/wink.gif ?

[albertos]

thanks wolf, nice work.does your water line go to the block next to your oil inlet or are they both going to therm/water in,and if u got time can u post pic of your inlet manaf just need to c were some hoses go is yours a map version ..thanks for your help

[albertos]

sorry i didnt c 3rd photo,just got to work out manafold

[.wolfwood]

sorry matt i just saw some of his other work and it wa much better, oh welsl shit happens, wats done is done.

if i could do it all over again i would have got a sr20 put in. prob cost the same about in the long run anyways.