ae71 5spd same as ae86 5spd

[solidc10]

the ae71 and the ae86 are these gearboxes the same ?????
i read somewere there is a 20 spline and a 22 spline is this true???

thanks danny

[rthy]

i have a ae71 t50 in my ae86, seems to be fine (all bolting in also)

[Brenton 86]

also have run ae71 t-50 behind the gze, im sure they are identical

[bahnugget]

i think from memory T18 T50's are are the ones that don't fit in AE86's.. but my memory's crap, lol.

[solidc10]

thanks peoples http://www.ae86drivingclub.com.au/forums/emoticons/2thumbs.gif
im buying a ae71 for spare......just wanted to make sure the gearbox was the same before i got it http://www.ae86drivingclub.com.au/forums/emoticons/wink.gif

will have some ae71 parts for sale soon

danny

[Gilly]

i think from memory T18 T50's are are the ones that don't fit in AE86's.. but my memory's crap, lol.[/b]

correct t18 output shaft is different

[flamingheads]

ta22 ones are different as well

[Javal]

ADM AE86 and AE71's are the same.

But JDM AE86 T50's are different, i don't know what's different though.

Javal.

[driftae86]

jdm t50's have different bellhousing. clutch fork, slave cylinder etc is on the drivers side. aus ae86 and ae71 have same gb as they have the same engine. both fit 4age too

[Javal]

Well there you go.

[Jesse86]

god damn thats helpfull

[solidc10]

yes it was http://www.ae86drivingclub.com.au/forums/emoticons/2thumbs.gif

will be wrecking the ae71 for sure now picking it up tomorrow.....

it has lots of good bits on it so i will posting in the for sale section soon

thanks for the help

[mech`s blue]

ok then if the ae71 and aus ae86 boxes both fit and the shafts the same, what about the bearings are they the same? cause my box needs a rebuild but can only get ae71 kits.

[Javal]

as the man said, they are the SAME.

same motor, same box, same driveshaft, same diff.

rebuild kit for an AE71 will be fine.

[Medicine_Man]

ADM AE86 and AE71's are the same.

But JDM AE86 T50's are different, i don't know what's different though.

Javal.[/b]

Apart from the different bellhousing the JDM gearboxes have bigger bearings than the Aus ones..

[RobertoX]

<{POST_SNAPBACK}> (index.php?act=findpost&pid=257736)

ADM AE86 and AE71's are the same.

But JDM AE86 T50's are different, i don't know what's different though.

Javal.[/b]

Apart from the different bellhousing the JDM gearboxes have bigger bearings than the Aus ones..
[/b]


wrong...

the jdm (5/85 - ) only have bigger 1st and 2nd syncros

zenki boxes are identical (without b/housing)

[joeschmo_57]

just to add....i tried to go to t18 box in my 86 and u cannot simply change bellhousings over and use a different tailshaft yoak, as the bellhousings form the front g-box seal and the oil gallieries are different (not by alot but enough to matter)

also T18's use a bigger tailshaft yoak