ae86 with 4agze has just stopped has nothing help

[shaun2]

tonight i went for a drive around town and as i went around one of the corners in town my microtec dash shut off for a second then light up again wichi thought was odd. then i went around another corner and it completely died. i now have no dash lights or ignition. i run a microtec mtx 8 computer and a 4agze engine if that helps any one. the car still cranks and battery is fine no bad terminals checked evey fuse to the computer and ignition system. can't find any thing wrong in that sense. only thig i found was some melted wires that go to the coils as they come off the loom and sat on the extractors. any help would be appreciated guys thanks.

[mikewestphoto]

Does it have spark?

Does fuel come out of the return end of the fuel rail if you pull the hose off?

[shaun2]

can't here no fuel lines going or pump not sure about spark will have to check in the morning and get back to you on that one asap

[slide86]

well usually melted wires going to the coil would be a problem

id say that there is no signal going to or from the coil due to the melted wires, causing no spark.

you need to fix this first before troubleshooting anything else

[shaun2]

it's all sorted out now thank you :2thumbs:

[Hen is a total nutcase]

To assist anyone in future who hits a similar problem, what was it that caused the problem and how did you fix it?