1 piece tailshaft length

[KE70briskev]

hey my buddy egg_83 is putting a ra40 diff into his 86 he has a t50 and was wanting to get a 1 piece tailshaft made up does anyone know what length it is :2thumbs:

[Hen is a total nutcase]

You'll need to measure it yourself. Bolt the uni to your diff. Slip the yoke into the box and measure the distance from the centre of front uni pin to the centre of the rear uni pin. Subtract 10mm to allow for suspension movement. Then take that measurement to your drive shaft maker.

Hen

[Brenton 86]

I just ran a tape from inside the spline of the g/be to the front of the diff flange, meraculously it turned out perfect, give that a shot