View Full Version : What tailshaft?
Stomp86
22nd October 2007, 12:38 PM
as topic....just put a tseries in my mates car...tailshaft doesent mach up...i heard t18 is the way to go...
anyone know?
thanx
Adam
hachirusto
22nd October 2007, 12:40 PM
does it have a t50 in it? can remember about ke70 but in ae86 u use front half and then the rear needs to be a jdm one or t18 because its slightly short allowing it to fit
ke70dave
22nd October 2007, 12:58 PM
if its stocko ke70, it will have a 4K motor, with either a K40 or a K50 gearbox. to put a T series diff in, you need to leave the front half of the trail shaft, and just replace the rear half with one from a T18.
Stomp86
22nd October 2007, 02:57 PM
the tailshaft is a single piece...i mean it bends in the middle but cant be seperated
its got a 4k in it
driftism
22nd October 2007, 03:03 PM
if it's a stock ke70 with a 4k you need a custom tailshaft for it.
I ran into this problem when i fitted my lsd diff to my ke so i could have some fun while the sprinter was being built. pity i forgot about the tailshaft not fitting until i had fitted everything else.
Stomp86
22nd October 2007, 05:08 PM
bugger that sux...yeah thats when we figured it out....after everything else was done..might just have to redrill the tailshaft
biggo
22nd October 2007, 08:43 PM
you need to shoten it. redrilling will cause the input to smash the gearbox bearing/seal
Stomp86
23rd October 2007, 11:12 AM
i found its actually about 10 mm too short hmmmm
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.