bee R help

[86adz]

I'm trying to install my bee r rev limiter and get it to work with my bigport 4age with standard adm ecu but I'm having some dramas. I've done a few searches and from what ive gathered I'm to hook the yellow wire from the bee-r to a 1 degree rpm signal which i have hooked to the black/yellow wire coming from the middle plug in the ecu with symbol 'IGf'.
the green to distributor/180 degree sensor which ive connected to the white wire coming from the end pin in the same middle plug. symbol (Ne)
red to +12v
black to earth
white optional to handbrake (havent connected mine to anything)

so i start my car and play with the dials and the bee-r responds correctly by flashing at the rpm i set it to limit at however its not cutting the spark i.e not rev limiting :confused:

anyone installed one sucessfully on 4age? or anyone else know what I'm doing wrong?

[DRFTAE86]

Bit off topic but put up a vid on youtube or something once you get it working...... wanna see how they do with a 4age. ;)

[86adz]

Got it working :) turns out i was going off the wrong ecu pinout diagram. So the correct wiring for my bigport ecu which has from left to right a 10pin plug a 18pin plug and a 14 pin plug was

Bee-R yellow wire to pin no.5 "IGf" in middle plug (black/yellow wire)
" green wire to pin no.4 "G-" in middle plug (black)

red to 12v
black to earth


http://www.ae86drivingclub.com.au/dcimages/4/8/4/3/167971.jpg (http://img139.imageshack.us/my.php?image=beerwiringch6.jpg)