View Full Version : 20v cam angle sensor pin outs
sdrawkcab
19th September 2011, 09:34 PM
I need the pin out for the 20v blacktop cam angle sensor on the back of the dizzy. There is red, white, black and green wires. It's going into a microleb lt10s so if anyone can clue me into which wires I connect that would be great. If not the in outs will do. Cheers guys.
Matt
21st September 2011, 04:36 PM
Are you using standard 20v loom or microleb loom.... When i changed an aftermarket ecu i just swapped everything at the ecu end.
B/Top pinouts for the ecu can be found here
http://forum.4age.org/index.php?/topic/365-wiring-up-a-blacktop-20v/
Silvertop / Blacktop dizzys are the same, and the silvertop pinouts can be found here
http://qrgarage.ca/wp-content/uploads/2011/08/silvertop_diagram.jpg
Can do also do a continuity test when i get home and upload a pic of the dizzy plug if that is easier?
meadan
21st September 2011, 05:58 PM
Im pretty sure the microtech will only use 3 of those wires.
www.microtech-efi.com
sdrawkcab
21st September 2011, 08:40 PM
yeah I'm rockin the microleb loom. I'm in the process of wiring it up now it only uses the 3. I need to know which is the wire for TDC and the trigger.
meadan
21st September 2011, 09:01 PM
If you would have looked at the microtech website, you would have found the wiring diagram. It tells you exactly what to connect to....shows a diagram of the plug and which wire to connect to it.
Try this :)
http://www.microtech-efi.com/downloads/28.pdf
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.