Skatan
8th October 2011, 10:45 PM
35mm thick for effective elimination of bumpsteer, along with the benefit of added camber and track.
CNC'd from 6061-T6 aluminum and anodized red. Machined T3 logo on upper face - does absolutely nothing for performance, but looks cool!
Comes with all mounting hardware and bolts.
These units incorporate the same CNC milled alignments sleeves and center block used on our Standard RCA's. This provides additional shear protection and insures that the units will stay properly aligned no matter how hard you drive.
We took a lot of time engineering and designing these units to insure the absolute best durability and strength possible. All hardware included is Metric Grade 10.9 and 12.9 alloy steel, that is equivalent to SAE Grade 8 and higher.
These Negative Camber RCA's will provide 2.8 degrees of camber on a car dropped 2". On a car dropped 3" they will provide 3.1 degrees of negative camber (these figures are IN ADDITION to the camber your car already has, so if you already have 1.2 degrees of camber at 2" drop, then you would have 4 degrees overall of negative camber)
These units will also widen the front track of the car by 25mm per side (50mm overall increase in front track). Used with Camber plates, they will allow you to run moderate camber with a much wider track or absolutely insane amounts of camber 5+ degrees.
copied the above from ebay add, was just easier
Used condition, all 8 bolts and 4 washers are together in snaplock bag.
Not too keen to post...... pickup from bondi area or I am working in Revesby mon-sat 7am-6pm
please call 0416461521
Thanks John
CNC'd from 6061-T6 aluminum and anodized red. Machined T3 logo on upper face - does absolutely nothing for performance, but looks cool!
Comes with all mounting hardware and bolts.
These units incorporate the same CNC milled alignments sleeves and center block used on our Standard RCA's. This provides additional shear protection and insures that the units will stay properly aligned no matter how hard you drive.
We took a lot of time engineering and designing these units to insure the absolute best durability and strength possible. All hardware included is Metric Grade 10.9 and 12.9 alloy steel, that is equivalent to SAE Grade 8 and higher.
These Negative Camber RCA's will provide 2.8 degrees of camber on a car dropped 2". On a car dropped 3" they will provide 3.1 degrees of negative camber (these figures are IN ADDITION to the camber your car already has, so if you already have 1.2 degrees of camber at 2" drop, then you would have 4 degrees overall of negative camber)
These units will also widen the front track of the car by 25mm per side (50mm overall increase in front track). Used with Camber plates, they will allow you to run moderate camber with a much wider track or absolutely insane amounts of camber 5+ degrees.
copied the above from ebay add, was just easier
Used condition, all 8 bolts and 4 washers are together in snaplock bag.
Not too keen to post...... pickup from bondi area or I am working in Revesby mon-sat 7am-6pm
please call 0416461521
Thanks John