PDA

View Full Version : Want to go lower........ but exhaust is stopping me !!!



nichy
17th October 2011, 06:25 PM
Hey All , so on the quest to get my ke70 dumped as i have a few sets of rear springs and adj coilovers in the front.

ATM im sitting at 80mm from crossmember to ground. just hits exhaust on speedhump's if going super slow and mad angle haha

have been thinking about making another exhaust to go along the tunnel...... but just thinking about clearance issues with t/shaft

anyone got pic's or is this a common thing to do ? lol

note: yes i know the legal limit a car has to be

cheers Nichy

Hachi_Tom
17th October 2011, 07:06 PM
make out of rhs to go next to chassis rail or if you are making your own, heat it up and bash into an oval.
solid mount to chassis for maximum effect

good mate of mine went RHS exhaust on his sr20 mx73 and it had heaps of clearance and didnt sound half bad!

lolwat
17th October 2011, 07:17 PM
oval would be better for flow, get your exhuast tucked right up near the floor, my ke is decked(was lower cause of 13's) and my trailing arm mounts hit anything before exhuast did

sundee
17th October 2011, 08:09 PM
hammer it and you will most probably adversely affect the flow,
if you tuck it up as close to the floor pan as you can, then run it up as close to the tail shaft as you can, you can actually get the exhaust sitting above the bottom of the rails , i ran a string line underneath, across the car as a guide and it can be done no worries.

Sam-Q
17th October 2011, 08:17 PM
why would the exhaust be the lowest point in the car? there's heaps of room for something under there

here:

http://www.ae86drivingclub.com.au/dcimages/4/8/4/3/148295.jpg

3" system and still not the lowest point

lolwat
17th October 2011, 08:33 PM
this thread is LOL

jakel
18th October 2011, 01:36 AM
Mine does the same but i'm not too concerned because if I hear anything else scraping its not good, haha :)

Rice86
18th October 2011, 08:12 AM
Why need more low?

nichy
18th October 2011, 12:07 PM
NEED.... NAH DONT NEED TO.... WANT.

just a bit of stuffing around .

think exhaust in the tunnel is the way to go

cheers Guys. will post pic's up

assassin10000
18th October 2011, 06:09 PM
Exh in tunnel = hot transmission. Best to make heat shields or atleast wrap it.

Andrew

sundee
18th October 2011, 06:51 PM
? ummm i think the tranny makes enough heat of its own

nichy
18th October 2011, 07:31 PM
22179

yeah the trans would get hot as anyways , just enough in the tunnel to get it above the rails

Sam-Q
19th October 2011, 02:18 AM
it doesn't go even close to the trans??