View Full Version : how do you make a 3vz bellhousing work with a beams
KE70GT
9th February 2013, 02:42 PM
Does anyone know what starter motor flywheel combination you should use when putting a 3vz bellhousing on to a beams i dont want to buy a 3vz starter motor if its not going to work with the beams flywheel
Celica RA45
9th February 2013, 08:32 PM
use the std beams 1 i might have 1 here .thats if you are using the 6speed
KE70GT
10th February 2013, 07:44 AM
use the std beams 1 i might have 1 here .thats if you are using the 6speed
i got some custom flywheel that was based off a beams one it takes a 225mm clutch but the 3vz used a 236mm clutch so i was thinking that the flywheel that i have will be too small in diameter for the 3vz starter motor
fantapants
10th February 2013, 09:27 AM
what gearbag are you planning on using????
KE70GT
10th February 2013, 10:55 AM
what gearbag are you planning on using????
running an r155 same as an r154 but the input sharft is shorter so it sits in the right spot
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.