Trev084
13th February 2015, 08:10 PM
Time to sell my HKS blower kit and GZE...
Bigport GZE:
Block-
Hot tanked.
Bored .5 over, ross racing 8.0:1 pistons, total seal rings.
Crank has been linished and measured.
Engine needs assembly and some parts (bearings, gaskets, studs or bolts and possibly an oil pump), engine has been bored and then hard honed to size and just needs a flex hone before install, pistons need to be installed onto the rods and the rings need to be gapped to suit the bores.
Head-
Stripped, bead blasted, standard valves buffed and ground (45 and 30 degrees).
Bigport N/A cams, standard spring/shim/bucket combo.
All standard porting and gears
HKS Blower:
Ogura clutch SX11
Stripped, cleaned, inspected and painted.
All brackets cleaned and painted, pulleys cleaned up on lathe
Only thing I don't have is the top water outlet to suit.
This blower setup will not fit a FWD unless you rethink where the brake master/booster and clutch master sits.
This is an UNFINISHED engine but selling well under what it has cost me so far.
I am looking for $1400 ono but I can also offer a finishing service through my workshop.
Located in Ipswich QLD, PM me if interested.
34755
34756
34757
34758
34759
34760
Bigport GZE:
Block-
Hot tanked.
Bored .5 over, ross racing 8.0:1 pistons, total seal rings.
Crank has been linished and measured.
Engine needs assembly and some parts (bearings, gaskets, studs or bolts and possibly an oil pump), engine has been bored and then hard honed to size and just needs a flex hone before install, pistons need to be installed onto the rods and the rings need to be gapped to suit the bores.
Head-
Stripped, bead blasted, standard valves buffed and ground (45 and 30 degrees).
Bigport N/A cams, standard spring/shim/bucket combo.
All standard porting and gears
HKS Blower:
Ogura clutch SX11
Stripped, cleaned, inspected and painted.
All brackets cleaned and painted, pulleys cleaned up on lathe
Only thing I don't have is the top water outlet to suit.
This blower setup will not fit a FWD unless you rethink where the brake master/booster and clutch master sits.
This is an UNFINISHED engine but selling well under what it has cost me so far.
I am looking for $1400 ono but I can also offer a finishing service through my workshop.
Located in Ipswich QLD, PM me if interested.
34755
34756
34757
34758
34759
34760