Looking for Sydney Workshop to help finish car off

[Mirko]

So have been building 86 for just over a year and was planning on doing most it my myself and so far so good but given l am knocking my house down in a few months need to speed up final steps of the build. My mechanic mate who was helping with conversion etc is a little pressed for time which normally ok but given my timeframe need to get more help.


Not a huge amount to do have most of the required parts but some work to do mainly the following

- New fuel lines
- Wiring (Thinking Justin from Prowire)
- Turbo manifold (Have someone for this)
- New brake lines but have that sorted
- Final motor install with installing everything else like alternator, fuel lines, water and oil.
- Need water line fabricated to radiator

Basically looking for workshop ideally in western Sydney to help speed it along. Does anyone have any recommendations for this. Used to go to bel garage back in the day with my S14 and l know a tonne of workshops but figured l would go to the community for any recommendations

Thanks in advance

[Matt]

What sort of quality do you want done for your cooler piping?

http://www.ae86drivingclub.com.au/dcimages/5/3/4/9/543827.jpg

http://www.ae86drivingclub.com.au/dcimages/5/3/4/9/543828.jpg

If it is just dropping a motor in, I could give you a bit of a hand one weekend. Wiring i'm ok at too. What ecu are you wanting to run?

[Mirko]

Ideally looking for a fixed pipe with sensor etc in it like in pic attached. Have a haltech ps1000 going in it need an entire custom loom for it. Motor has been in a few times so thats simple enough its for more finishing it all up.

3505935060