Futo_gt86
27th July 2015, 08:39 AM
Heya,
I have a T series form series 2 T18 that has been sitting around.
I pulled it down to get ready for install into KE70,
When I removed the drums, there was small spring with 4 seats laying in the bottom of the drums (did this both sides)
The springs for the shoes where there, in place, no foul.
The wheel cylinders were all intact, rubber boots attached.
I take it they are from the handbrake cable?
If so how should they go back in?
Ali
I have a T series form series 2 T18 that has been sitting around.
I pulled it down to get ready for install into KE70,
When I removed the drums, there was small spring with 4 seats laying in the bottom of the drums (did this both sides)
The springs for the shoes where there, in place, no foul.
The wheel cylinders were all intact, rubber boots attached.
I take it they are from the handbrake cable?
If so how should they go back in?
Ali