GeeEss
7th October 2015, 09:53 PM
I'd like to wire a knock sensor into my Series 2 N/A Bigport.
I haven't yet been able to confirm this (due to its PITA location) so would like to know if the 4AGE / 4AGZE block castings are basically the same; i.e. if there's a a raised boss+threaded hole at that location on the N/A Bigport 4AGE as-per Bigport 4AGZE.
Can anyone confirm this? If so I will rip a unit off a 90-93 Tarago.
If there is NO threaded hole then I will have to use another aftermarket unit as there's no way I'm removing the inlet & tapping one.
I've heard a Nissan SR20 sensor will do the trick and that apart from it being 1/10 the price of a new Toyota unit - it's a better / more modern design.
I'm asking as I'd like to wire Sensor and a couple of Aux. Loads into ECU this W/E but can't access the car to see which sensor I'll need until Saturday afternoon.
I haven't yet been able to confirm this (due to its PITA location) so would like to know if the 4AGE / 4AGZE block castings are basically the same; i.e. if there's a a raised boss+threaded hole at that location on the N/A Bigport 4AGE as-per Bigport 4AGZE.
Can anyone confirm this? If so I will rip a unit off a 90-93 Tarago.
If there is NO threaded hole then I will have to use another aftermarket unit as there's no way I'm removing the inlet & tapping one.
I've heard a Nissan SR20 sensor will do the trick and that apart from it being 1/10 the price of a new Toyota unit - it's a better / more modern design.
I'm asking as I'd like to wire Sensor and a couple of Aux. Loads into ECU this W/E but can't access the car to see which sensor I'll need until Saturday afternoon.